| 360° View - Cooljag Falcon 92-Cu
Information on Frostytech's test
methodology is available here.
The Heatsink Fan:
The 92x92x25mm fan on the Cooljag
Falcon 92-Cu is thermally responsive. It spins at 1200-2500RPM depending
on the temperature sensed by a thermistor located off the side of the
motor housing. Noise levels range from 31 dBA to 53 dBA
according to Frostytech's real world should level measurements. The fan connects via a
4-pin PWM compliant motherboard fan header and is backwards compatible with 3-pin connectors. The translucent
7-bladed fan impeller is internally illuminated with a pair of green LEDs.
There is no fan grill to protect the impeller from errant wires,
so keep the inside of your case neat and
The copper fins are soldered to the copper heatpipes, and each fin is about 0.2mm thick. Fins are spaced 1.3mm
apart, and measure approximately 100x106mm. The two central heatpipes are placed under the fan motor, but the remainder of their
length gets the full dose of airflow from the fan impeller.
The Cooljag Falcon 92-Cu stands 112mm tall, and the fins make
up 78mm of that figure.
The 92mm fan is set within the cooling fins, but the heatpipes are arranged in a straight line.
The raised edge of copper cooling fins gives some protection to the fan blades. The bulk of
the heatsink is elevated 37mm above the base, so there is good clearance for adjacent capacitors and the
like. Note the LGA775 mounting brackets are attached in this image.
Heatsink Side B:
Below the fan is 43mm worth of
cooling fin. That is pretty substantial given the positioning of the four heatpipes. Just above
the copper base block is the skived aluminum base cap heatsink. The four heatpipes are soldered to
the copper below, and the skived aluminum heatsink makes tangential contact with the copper tubes.
Its conductive powers are apt to be quite minimal given the bulk of cooling
||Heatsink Side B:|
There is a 5.5mm plenum below the 92mm fan.
We would have expected guards at either side of the heatsink to help
direct airflow down into the body of the cooler, but as you can see there
The copper base of the Cooljag Falcon 92-Cu
heatsink is polished very smooth, but the base is very convex in one axis
and a little wavy in the opposite. This will impact thermal conductivity substantially,
and may account for the
Falcon 92-Cu performing nearly identical to the Falcon
92-Al. Variances will always exist so apply a good even coat of thermal compound with
the included spatula... or try your hand at lapping if it
demands. The base measures 48x42mm, and is at least 2mm thick,
5.0mm on average. Surface roughness is at or better than ~16 microinches, which is considered
excellent. Note the four screws for attaching the side metal mounting