 |
Tweakbox Liquid Neon Light Kit
|
|---|
| Sat Jun 02, 2001 | 4:45P| PermaLink |
|
|
"The only hard part of the installation is setting the power switch into a drive bay. Note, this step is *completely optional*, but it really makes it easier to turn the light on and off, and it compliments the look of
your case as well. For installation, you're supposed to cut the hole out on a 5.25" bay with an included template. However, I found it too hard to cut that small of a circle with dremel cut-out wheels. So, I recommend getting some
large drill bit (I used a huge 1/2" bit) and drilling a hole through the center of the template, like below..."
|
|
FULL STORY @
RIZENET
(http://www.rizenet.com/hardware/blueliquidneon/page1.php)
|
|
|
