 |
1U/5v Cooler Mod Guide
|
|---|
| Tue Jul 23, 2002 | 4:05P| PermaLink |
|
|
After going to my balcony and setting up the "workstation" (old magazines for a table and a plastic bag as the floor mat), I was ready for some cutting. Basically I needed to shave off about 2-3mm from one of the sides. There was a convenient protrusion from the bottom but it was slanted inward to I decided against cutting from that side. This was dumb, since in the end that would have been the easier route. Instead, I started cutting the fins from the top. There was a lot of slipping, a lot of bending, and a lot of sweating. Two of my wheels broke in the process (either the rotation speed was too low or they got temporarily stuck in the fins). I could have sworn one of them bounced off my goggles before vanishing; good thing I had a pair on. After going through four wheels with little done I decided enough is enough.
|
|
FULL STORY @
MIKHAILTECH
(http://www.mikhailtech.com/articles/mods/mx440mod/)
|
|
|
