 |
Rob's Holesaw blowhole mod article
|
|---|
| Wed Aug 07, 2002 | 7:27P| PermaLink |
|
|
"The first stage of the prepping for the cutting is to mask off the holes. I de-tacked the masking tape by sticking it to my clothes then pulling it off, so as to not damage my case's paintwork when it is removed after cutting, then stuck it so it covered the mounting holes and the hole itself. Once this has been done you come across one problem, you cannot see the holes that you punched, but don't worry, if you push the masking tape down enough and scan the surface you can see where the punched holes are. To make them easier to see once you have found them pencil or pen in a dot over it."
|
|
FULL STORY @
PHLUX
(http://phlux.co.uk/articles.php?aid=31)
|
|
|
