 |
guide to making baybus`s
|
|---|
| Fri Oct 06, 2000 | 4:21P| PermaLink |
|
|
"Measure and mark out blanking plate, obviously if you want it to look
anything like, you're going to have to use a rule J I tend to like to make
things pretty much even, so I measure the plate, approximately 155mm,
subtract the width of the Temp. Module, then divide this by how many gaps
you going to want (5 switches plus temp mod = 7 gaps) this way, hopefully
things are going to look nice and even."
|
|
FULL STORY @
HEXUS
(http://www.hexus.net/baybus.shtml)
|
|
|
