 |
PROJECT TYAN TIGER 133
|
|---|
| Fri Sep 22, 2000 | 12:36P| PermaLink |
|
|
"Well out came both processors and the A14 "trick" was applied. (See Tom's Hardware.) This proved to be a worthless attempt on this motherboard, so I began the process of populating the PCI slots with all my hardware. Because the Tiger 133 does not support the Adaptec RaidPortT SCSI controllers, I elected to use an AMI MegaRaidT 428 dual channel controller. Because the two AMI raid controller share the Firmware over the PCI bus, slot selection was a problem because the Award Bios of the Tiger seems to "dislike" this arrangement. Finally after placing the AMI 428 in slot one and the AMI 434 in slot 4, I got a full boot."
|
|
FULL STORY @
OCTOOLS
(http://www.octools.com/articles/Tyantiger/tyan.html)
|
|
|
